xvincex Posted April 15, 2004 Share Posted April 15, 2004 Hello, I'd like to plug my Ampeg B2R into a Ampeg SVT-810e Cabinet and I'm wondering which outpout of the head abd which input on of the cab I should use to get a 4ohm load (350 watts) Owner's manuels on the Ampeg website shows rear backs but It's not written anywhere for what I'm lookin. Link to comment Share on other sites More sharing options...
Basshappi Posted April 15, 2004 Share Posted April 15, 2004 You should be able to use either one. The power amp wil "sense" the load and supply the rated power. Just remember that the B2R cannot handle a load lower than 4ohms.Always follow the connection guide for hooking up multipule cabs. As far as the cab is concerned, there are 5 jacks on the back panel. 1- 1/4" on top, 2 -1/4" in the miiddle, and 2 speakeron jacks on the bottom. According to the manual (which you can download from their website), You need to plug into one of the 1/4" jacks in the middle(if you are using 1/4" connectors of course). This will run the cab as an 8x10 with a 4ohm load. Plugging into the top 1/4" jack splits the cab into 2- 4x10 cabs running at 8ohms each. Ampeg Nothing is as it seems but everything is exactly what it is - B. Banzai Life is what happens while you are busy playing in bands. Link to comment Share on other sites More sharing options...
xvincex Posted April 16, 2004 Author Share Posted April 16, 2004 Do you think it's better to plug it 2 4x10 or 8x10? Link to comment Share on other sites More sharing options...
Basshappi Posted April 16, 2004 Share Posted April 16, 2004 Unless you are bi-amping, Run it 8x10. Nothing is as it seems but everything is exactly what it is - B. Banzai Life is what happens while you are busy playing in bands. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.