EdMusic Posted March 22, 2007 Share Posted March 22, 2007 I've just added a 2nd board and am currently re-creating all of my setups. So far no problem at all. The 2nd board follows the RD setups as programmed as long as i make use of setups. But when i want to make use of the one-touch piano, the RD keeps sending midi data and triggering the 2nd board. For now i could not find a way to set midi-tx data for the one-touch piano's. Any suggestions. rgds. Roland FA-08 Nord StageEX compact Yamaha MG10/2 Link to comment Share on other sites More sharing options...
raddtunes Posted March 24, 2007 Share Posted March 24, 2007 Hi - I hope I can help you. I just went and double checked, and if I understand your question correctly - the one-touch piano is, in fact, a setup - which you can edit, and then presumably store in some other location. To the left of the screen is a group of 6 buttons - upper left-hand one says External/Internal. Push that - when lit, you have access to the screen where you route MIDI traffic from each of the four zones. In this case, of course, you only have one active zone. You'll want to change the setting of the MIDI output to which Zone 1 is sending its notes. Hope this helps - and good luck. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.